Slurry pump manufacturer sump assembly sequence Sump slurry pump manufacturer in the course of various reasons need to be assembled for the next regulate fluid slurry pump manufacturer assembly operations , avoid unnecessary trouble , here under the liquid slurry pump manufacturer assembly sequence , as long as you follow this sequence come , there would be no problem.
1 , The bearings were installed in the bearing housing and bearing housing .
2 , Will be installed in the bearing cartridge bearing wear on the shaft and tighten the nut on the circle , and a bearing cap fastened to the bearing box .
3 , The shaft into the bearing, bolted , screwed adjustment screws and bearings mounted on the support base , the retaining trap in place at the lower bearing .
4 , The connection tube is fixed to the bearing housing and the lower portion of the tube in the coupling head mounted on the pump , the impeller mounted on the lower shaft and tighten sequentially mounted on the pump body front cover and bolt , by adjusting the adjustment screw of the bearing housing the gap between the impeller and the front cover , ( control 1 – 1.5mm) after a good tune with nuts , bolts tightened.
5 , The motor bearing mounted in the bearing housing bolted , slurry pump manufacturer mounted at the upper end of the shaft coupling parts and motor coupling the fastening screws at the head of the motor shaft , the motor is mounted on the motor support and use bolts, nuts .
6 , From the produced fluid slurry pump manufacturer in order to asbestos pads, elbow out the liquid , the liquid tube mounted on and fixed to the support base.
Post time: Jul-13-2021