Slurry maintenance problems

Slurry maintenance problems

1 Slurry flow primarily to transport for the purpose of running the monitoring system is preferably mounted on the flow meter to monitor traffic at any time to meet the requirements; equipped with cyclone pipeline system, slag system, filter press dewatering pipeline system also requires a certain pressure at the outlet. Therefore, in such a system should be fitted with a pressure gauge to monitor compliance.

2 Slurry pump should start before shipment inlet valve closed slurry pump outlet valve. Then start the pump, the pump starts and then slowly start the pump outlet valve, pump outlet valve size and speed should be no vibration pump and motor are not over-rated current to grasp.

3 In series with the pump start and also to follow the above method. Just after opening stage pump can pump outlet valve at the end to find a little opening, the size of the opening level of the pump motor current to the rated current of 1/4 is appropriate, then you can have two three start until End-stage pump, pump all started after the series, slurry pump manufacturer you can gradually opening the final stage of the pump outlet valve, the size of the valve opening speed, vibration, and should not in any stage slurry pump motor is not over-rated current to grasp.

4 Pumps in operation in addition to monitoring of flow, pressure, but also to monitor the motor should not exceed the rated motor current. At any time to monitor oil seals, bearings, etc. are often guided phenomenon occurred, whether there evacuated or underflow slurry pools and ready to deal.


Post time: Jul-13-2021