Slurry maintenance policy measures
Slurry series according to the liquid should be selected , and check the required performance , analysis suction and discharge conditions , the intermittent operation or continuous operation and so on .
Slurry series should normally be at or near the manufacturer ‘s design requirements to run under pressure and flow conditions . Anyone familiar with the mechanical structure is solved , Slurry is a simple machine . Care should be taken in the rated range, can not load running , taking care to avoid the phenomenon of cavitation and vapor tied to step up inspections , and timely replacement of worn seal member .
( 1 ) Check the Slurry pipeline and junction without loosening . Rotate the Slurry, Look Slurry is flexible.
( 2 ) Adding to the bearing body bearing lubrication oil, observe the oil level should be the subject of the centerline oil , lubricating oil should be replaced or supplemented .
( 3 ) Remove the drain plug diversion Slurry pump , filling water .
( 4 ) Close the outlet valve and outlet pressure gauge road .
( 5 ) To move the motor , Wuxi pipe Look motor rotation is correct .
( 6 ) Start the motor , when Slurry normal operation , open the outlet pressure gauge , as it shows the proper pressure , gradually open the valve, and check the motor load conditions .
( 7 ) Slurry try to control the flow and head at the range on the label to ensure Slurry operate at maximum efficiency , to achieve maximum energy savings.
(8) Slurry during operation , the bearing temperature must not exceed the ambient temperature 35 ℃, the maximum temperature Wuxi pipe shall not exceed 80 ℃.
( 9 ) If there is abnormal sound found Slurry check the reason should be immediately stopped .
(10) Slurry To stop , turn off the valve, pressure gauge, then stop the motor.
(11) Slurry at work within the first month , after 100 hours to replace oil , after every 500 hours , oil change once.
( 12 ) Regularly adjusted packing gland to ensure that conditions are normal packing drip chamber .
( 13 ) Regularly check the wear sleeve , wear large rear should be replaced.
(14) Slurry is used in the winter season , parking, the need to pump drain plug unscrew the lower the media put the net . Prevent cracking .
(15) Slurry long-term disabled Wuxi pipe , the need to pump all apart , dry water , and the junction of the rotating parts coated with grease installed for safekeeping . slurry pump manufacturer Blasting or shot peening , are not completely decontamination . In the conventional processing method , the best cleaning effect or blasting.
Post time: Jul-13-2021